Yes, you can put a skylight on a flat roof. Low-slope roofs work the same way. In Los Angeles, plenty of homes already have one. The skylight itself is only half the story. On a flat roof, the raised curb and the flashing around it are what keep water out. Get those wrong and the unit will leak, even if the glass is fine.
Here’s how a flat-roof skylight is supposed to work, what we look for, and when you can keep the curb you have.
Why a flat or low-slope roof needs a curb
A pitched roof sheds water past a skylight. A flat or low-slope roof does not. Water sits, moves slowly, and can pond against anything that sticks up. If a skylight sits too low to the roof surface, water has nowhere to go but under the frame.
That’s why flat-roof skylights sit on a curb: a short wood box built into the roof. The skylight mounts on top of that box, up out of the water. The roof membrane turns up the sides of the curb, and the skylight’s frame caps the top. Think of it like a lid on a shoebox. The box keeps the lid above the puddles.
On steeper roofs you sometimes see deck-mounted skylights that flash right into the shingles. On flat and low-slope roofs in LA, curb-mounted is the standard setup. We cover the difference in curb-mounted vs. deck-mounted skylights.
Rule of thumb: on a flat or membrane roof, the curb usually needs enough height for a full membrane turn-up, commonly around 8 inches above the finished roof. Skylight makers often list a lower number aimed at pitched roofs. Use the higher of the skylight and roofing requirements.
How a flat-roof skylight is flashed
A watertight flat-roof skylight is a stack of parts, not just a pane of glass:
- The curb. Square, solid, and fastened into the framing, not just the deck. Soft or rotten wood under an old unit is a common find.
- The membrane upstand. Roofing turns up the outside of the curb and is sealed at the top. Corners are the weak point.
- A cricket, when needed. On the uphill side of a wider curb, a small tapered saddle sends water around instead of letting it pool against the box.
- The skylight on top. It sits on the curb with the manufacturer’s gasket or seal. Sealant alone is not flashing.
- Counterflashing or the unit’s own cap. It covers the top edge of the membrane so water sheds onto the face of the curb, not into it.
Our skylight glossary explains each of these terms.
We’re a glazing company. We replace skylights and glass. We don’t reroof. On a flat roof, the membrane work around the curb usually belongs to the roofer. We handle the unit, the curb under it, and how the skylight seats on top.
Why we pitch the curb under flat glass
Our flat glass skylights mount level on a flat roof. Ideally, we pitch the curb under them so water runs off the glass.
Not every maker asks for this. Velux doesn’t require it, and Velux skylights are rated for 0° installations. Custom manufacturers do require it. It’s still best practice to pitch the curb. The glass stays cleaner longer, and it prevents ponding on the glass.
What usually fails on older LA flat-roof skylights
Most “skylight leaks” on flat roofs are not broken glass. They’re at the curb and flashing:
- A curb that’s too short for the membrane turn-up the roof needs
- Dried or piled-up sealant used as a substitute for real flashing
- Rot in the wood curb from years of slow leaks
- Open membrane corners, and debris banked against the curb after dry months
- An old acrylic dome that has yellowed, gone brittle, or cracked from heat and UV
If stains show up only in wind-driven rain, that often points to flashing or curb height, not a crack in the glass. Our guide to why skylights leak explains how to tell a roof leak from a unit problem.
Keep the curb, replace the skylight, or do both?
You don’t always need a full rebuild. We look at the unit, the curb, and how the roof ties in, then tell you what has to change.
Our repair vs. replace guide covers the same questions for the unit itself.
Often fine to keep the curb
- The wood is solid, square, and tall enough for a proper membrane turn-up
- The flashing or membrane upstand is sound, with tight corners
- Only the skylight itself is failed: fogged glass, a cracked dome, failed seals
Then a skylight replacement on the existing curb is the clean job. The membrane stays. The new unit drops onto the curb.
Usually needs more than a new unit
- Soft, rotten, or out-of-square curb wood
- A curb that sits too low for the roofing system
- Open corners, lifted membrane, or years of caulk patches
- Leaks that never fully stopped after “resealing”
Then the curb gets repaired or rebuilt, and the roofing around it gets redone with it. The roofer and the skylight company both need to be on the same plan. If a new roof is coming, deal with the skylights before tear-off.
Adding a skylight to a flat roof vs. replacing what’s there
Adding a skylight where there wasn’t one means a new opening, curb, roof tie-in, unit, and interior shaft. It’s a multi-trade job. Replacing a failed unit on a sound curb is usually one trade and one visit. That’s why replacement and new skylight installation are scheduled differently.
On LA flat roofs we also talk through glass vs. an older plastic dome. Glass is clearer, lasts longer under the sun, and is quieter in the rain. You don’t have to upgrade every time. If the dome is already shot, glass is usually the stronger long-term choice. See glass vs. acrylic vs. polycarbonate.
Cost depends on the unit, the curb and the roof tie-in. See our guide to what skylight replacement costs.
Frequently asked questions
Can you install a skylight on a flat roof?
Yes. In Los Angeles it’s common. The unit goes on a raised curb above standing water, and the roof membrane flashes up the curb. A skylight set flat to a low-slope deck with almost no curb height is a leak waiting for the next hard rain.
How tall should a flat-roof skylight curb be?
High enough for a full membrane turn-up above the finished roof. On membrane roofs that commonly means around 8 inches. Some skylight instructions list a lower minimum meant for pitched roofs. We match the higher of the skylight and roofing requirements for your roof type.
Should a flat glass skylight sit level?
It can, but ideally it doesn’t. Velux doesn’t require a pitched curb, and Velux skylights are rated for 0° installations. Custom manufacturers do require it. We pitch the curb as best practice. Water runs off, the glass stays cleaner longer, and it prevents ponding.
Do skylights leak more on a flat roof?
Not because of the glass. On a flat or low-slope roof the water sits and drains slowly, so the curb height and the flashing around it do all the work. When a flat-roof skylight leaks, that’s usually where it’s coming from, not the unit itself.
Does a leaking flat-roof skylight always need full replacement?
No. If the glass or dome is fine and the leak is at the flashing, the fix may be roofing and curb work. If the unit is fogged, cracked, or decades old and the curb is sound, replacing the unit alone may be enough. We sort that out on the roof.
Who handles the curb flashing?
Usually both trades, in their lanes. We handle the skylight and what sits on the curb. The membrane that turns up the curb is roofing work. On a reroof or curb rebuild, we line up the order with your roofer.
Have a flat-roof skylight that’s staining or fogging?
Hollywood Skylights has been in business for 12 years, with more than 20 years of experience in skylight replacement, repair and installation across Los Angeles. We’ll get on the roof and tell you straight what should stay and what should go.
Call us at (213) 334-3947 or request a free estimate.
