Los Angeles Skylights

Tempered vs. Laminated Skylight Glass: What Goes Over Your Head

Short answer: you want both. On a glass skylight, the outside pane should be tempered and the inside pane should be laminated. That’s the tempered vs. laminated skylight glass question settled. Every glass skylight I put on a house is built that way.

The rest of this is why, plus the two other things people ask about: Low-E and frosted glass.

Glass over your head is different

A window breaks and the glass lands on the floor next to it. A skylight breaks and the glass comes down on whoever is standing under it. In a kitchen. Over a bed. Over a kid doing homework.

So the question isn’t just “will it break.” It’s “what happens when it does.”

That’s the whole reason skylight glass is built in two layers that do two different jobs.

Tempered goes on the outside

Tempered glass is heated and cooled fast so it gets much harder than regular glass. It takes the weather, the sun, and the odd branch or ball.

When tempered glass does break, it breaks into lots of small pebbles instead of long, sharp pieces. Think of a car’s side window. That’s a big improvement over plain glass.

But small pebbles still fall. If the only layer up there were tempered, a break would still rain glass into the room. That’s why it goes on top, not on the bottom.

Laminated goes on the inside

Laminated glass is two thin sheets of glass with a plastic layer bonded between them. If it cracks, the plastic holds the pieces in place. It looks like a spider web, and it stays up.

That’s the layer you want facing the room. California requires laminated glass on the interior side of skylights for exactly this reason. (Our skylight glossary has the short definitions if you want them.)

So a good glass skylight is really a sandwich. Tempered on top, an air space in the middle, laminated on the bottom. The tempered pane handles the hits. The laminated pane makes sure nothing comes through.

The version I don’t use

Some skylights are sold with tempered glass on the inside too. Tempered over tempered.

I don’t use it. Not even when it’s a little cheaper. If you’re replacing a skylight anyway, the inner pane is the one thing between broken glass and your family. It should be laminated.

If you already have tempered over tempered and it isn’t broken or leaking, you don’t need to rip it out tomorrow. Just know what you have, and when it’s time to replace it, go laminated on the inside.

Low-E is the coating, not the glass

Low-E is a thin coating on the glass. You mostly can’t see it. It cuts the heat coming through and blocks most of the UV that fades floors and furniture.

In LA that matters. A clear skylight with no coating turns a room into an oven by August. Low-E is a big part of why a modern glass skylight doesn’t do that.

It also helps with California’s energy code. When a skylight gets replaced, the new glass has to meet the state’s energy numbers, and the Low-E coating is a big part of how it does. I pick a coating that meets them without paying for more glass than the job needs.

Low-E sits on one of the panes inside the sandwich. It doesn’t change the tempered-over-laminated setup. You get both.

Frosted is laminated too

Some rooms don’t need a view of the sky. A bathroom. A room where direct sun is too much.

For those, the inner pane can be white laminated glass instead of clear. It’s still laminated, so it still holds together if it breaks. It just spreads the light out soft and even. You get the daylight without the glare, and without your neighbor’s palm tree in the shower.

Clear or frosted, the safety part is the same.

What about plastic domes?

A lot of older LA houses still have acrylic or polycarbonate bubbles. Those are a different animal. No tempered, no laminated, no Low-E. I wrote about that comparison in glass vs. acrylic vs. polycarbonate.

If your dome is cracked, yellow, or brittle, a flat glass replacement with this two-layer glass is usually the move. Our skylight replacement page covers how that job goes.

How to tell what you have

Most safety glass has a small stamp in one corner. It’s often hard to read from the floor, and on a lot of older units it’s worn off.

Easier way: send me a photo of the skylight from inside and, if you can safely get one, from the roof. I can usually tell what it is. If not, I’ll check when I’m up there.

One more thing to look for. If you see fog between the two panes that you can’t wipe off, the seal on that glass has failed. It usually doesn’t leak, but the glass is near the end. On many skylights I can replace just the glass and keep the frame. That’s on our glass replacement page.

Quick questions

Is tempered or laminated glass better for a skylight?

Both, in the right spots. Tempered on the outside for strength. Laminated on the inside so a break stays up.

Is laminated glass required for skylights in California?

Yes, on the interior side. That’s why every glass skylight I install has a laminated inner pane.

Does Low-E glass make a skylight darker?

A little, but not in a way most people notice. It mostly cuts heat and UV. The room still gets plenty of light.

Can I get frosted glass on a replacement skylight?

Yes. The inner pane becomes white laminated glass. Same safety, softer light.

My skylight is tempered on both sides. Do I have to replace it?

Not if it’s sound. When it does need replacing, put laminated on the inside.

If you want to know what’s in your skylight, or you’re ready to swap an old one, call me at (213) 334-3947 or request an estimate. Send a photo if you can. I’ll tell you what you have and whether it needs anything at all.

Let's talk about your bright idea.

New build, a tired old skylight, or something in between, it's a good problem to solve. Send photos or just tell us what you're picturing, we respond within one business day.

Get a Free Estimate